As was mentioned earlier. We are/will be doing more electronic design than physical construction over the coming weeks. Here is a sample of the 3D analysis that is being done to determine optimal runs for plumbing and verify placements/sizes of interior cabinetry. The model shown here is built up from "real" locations taken from the floor supports already installed. Therefore, the bulkheads in the model, though not installed, are actual as far as where they will be placed. Its hard to notice, but the main salon section is shown with the floor removed to reveal the tanks. The stern of the hull is a little "fat", in terms of its curvature, and needs to be brought in a couple inches, but the bow is pretty close.
For the very latest activity, click here: From a Bare Hull
Batteries Bilge Bilge Pumps Blog Bow Pulpit Bow Thruster Bulkheads Cabinets Cable Master Canvas Cockpit Construction Coosa Deck Deck Hardware Design Dinette Distributed Power Driveline Electrical Electronics Engine Engine Room Equipment Exterior Fiberglass Finish Work Floors Fuel System Fun Gadgets Galley Hard Dodger Head Heating and Air Conditioning Ice Box Ideas Insulation Interior Keel Lighting Main Salon Mastervolt Masts Materials Mechanical New Technologies Off Topic Paint Panel Philosophy PlasTeak Plumbing Portlights Ramblings Rigging Rudder Sailplan Sails Sanitation Steering Tanks Techniques The Other Boat The Shop Thru-hulls Tick Stick Tools V-Berth Welding Wiring Wood