|Water pumps and filters|
For the very latest activity, click here: From a Bare Hull
Batteries Bilge Bilge Pumps Blog Bow Pulpit Bow Thruster Bulkheads Cabinets Cable Master Canvas Cockpit Construction Coosa Deck Deck Hardware Design Dinette Distributed Power Driveline Electrical Electronics Engine Engine Room Equipment Exterior Fiberglass Finish Work Floors Fuel System Fun Gadgets Galley Hard Dodger Heating and Air Conditioning Ideas Insulation Interior Keel Lighting Main Salon Mastervolt Masts Materials Mechanical New Technologies Off Topic Paint Panel Philosophy PlasTeak Plumbing Portlights Ramblings Rigging Rudder Sailplan Sails Sanitation Steering Tanks Techniques The Other Boat The Shop Thru-hulls Tick Stick Tools V-Berth Welding Wiring Wood
Sunday, April 22, 2012
Water Pumps Are In
Under the floor of the forward salon, the raw and fresh water pumps are now mounted and plumbed to their sources (fresh water tanks and raw water input hose). 24 volts were applied to both to verify that they actually worked. On the fresh water side, two filters are added. One to remove dirt and sediment, the other to remove bad tastes and odors. Next is to work out the distribution manifolds with the SeaTech fittings, which will go in the same compartment. This will tie together those red/white/blue hoses shown in the picture.