I had been postponing this project for as long as possible as it required another sheet of Coosa (expensive stuff). But I could wait no longer (dependent projects are creeping up). This is the secondary framing for the aft cabin settees. It divides the locker space underneath and provides some structural reinforcement. Instead of fiberglass and resin, the joints against the hull were glued with structural adhesive (easier to apply, less messy and just as strong).
It does not look like much, but there are lots of cleats that were "cut, mitered, fitted, trimmed, repeat..." down to half blade-widths. Lets just say I got a good workout on the stairs into the boat.
For the very latest activity, click here: From a Bare Hull
Batteries Bilge Bilge Pumps Blog Bow Pulpit Bow Thruster Bulkheads Cabinets Cable Master Canvas Cockpit Construction Coosa Deck Deck Hardware Design Dinette Distributed Power Driveline Electrical Electronics Engine Engine Room Equipment Exterior Fiberglass Finish Work Floors Fuel System Fun Gadgets Galley Hard Dodger Head Heating and Air Conditioning Ice Box Ideas Insulation Interior Keel Lighting Main Salon Mastervolt Masts Materials Mechanical New Technologies Off Topic Paint Panel Philosophy PlasTeak Plumbing Portlights Ramblings Rigging Rudder Sailplan Sails Sanitation Steering Tanks Techniques The Other Boat The Shop Thru-hulls Tick Stick Tools V-Berth Welding Wiring Wood